The Component: Genuine Yazaki 7114-4415-02 male flat tab automotive crimp terminal. RH / HS Series 0.64mm (.025) nominal blade width pin contact (Tin-Plated Copper Alloy / Loose Piece format / Engineering part number: 7114-4415-02 / Mates with female socket terminal: 7116-4415-02).

Applications & Fitment: Designed as a high-reliability, factory original equipment (OE) internal pin contact solution for low-voltage wire-to-wire inline harness junctions and flying leads. It serves as the definitive male pin connection interface inside the Yazaki RH connector family, seating perfectly within multi-pin inline male cap housings such as the 7282-8855-30 8-way dark grey male coupling cap. Widespread across global Japanese vehicle architectures—most notably on Toyota, Lexus, Nissan, Honda, and Mitsubishi platforms—it is typically relied upon within extension looms for oxygen sensors (O2), mass airflow (MAF) adapters, taillight harness extensions, and chassis-to-bumper wire intersections.

Engineered to preserve absolute structural strength and low contact resistance under taxing vibration cycles. Highly vulnerable to tab bending or twist damage if field technicians roughly force misaligned mating housings together, or if the terminal backing is crushed using non-profiled generic workshop hand pliers instead of the correct parallel terminal crimp press.

Technical Attributes:

- Manufacturer Part Number: 7114-4415-02 / 7114441502 (Brand: YAZAKI Corporation / Genuine Premium Automotive Class)

- Product Series Taxonomy: Yazaki RH Series / HS Series / 0.64mm (.025 inch) Flat Contact Terminal Group

- Contact Gender: Male (Flat Tab / Pin Profile)

- Mating Tab Sizing: 0.64mm nominal blade width tracking geometry (3.0mm horizontal pitch layout)

- Primary Seating Architecture: Relies on an internal housing plastic lance lock mechanism that snaps cleanly behind the male terminal shoulder once fully pushed into the cavity bay

- Base Structural Compound: Premium high-conductivity Copper Alloy stock for maximum circuit efficiency

- Contact Surface Plating: High-grade Tin-plated (Sn) finish for enhanced corrosion protection and uniform contact force

- Target Wire Gauge Section (AVS/AVSS): Precision optimized to accommodate ultra-thin-wall automotive primary cabling from 0.30mm² up to 0.50mm² boundaries

- Target Wire Gauge Section (AWG Equivalent): Built to cleanly crimp standard 22 AWG to 20 AWG electronic vehicle wiring runs

- Sealing Configuration: Engineered strictly for Single Wire Seal (SWS) applications; requires an individual silicone cavity rubber sleeve (such as the blue 7158-3165-90 seal) crimped into the rear insulation tabs to preserve watertight isolation

- Circuit Performance Thresholds: Certified for low-voltage signal distribution, delicate logic paths, and high-speed sensor telemetry networks (Low Level Contact Resistance: 8 mΩ Maximum Initial)

- Core Housing Compatibility: Seats perfectly across the entire Yazaki RH male inline connector series spectrum, including the 7282-8855-30 (8-way) inline male shroud block

- Packaging Format: Supplied as individual loose pieces for small-batch wire repairs, harness customization, and prototype workshop builds. Tiered commercial wholesale discounts apply automatically at check-out for trade auto-electrical stockists.